Low-water Use Tips To Meet Restrictions and Good Water Sense

We spend a lot of time talking about xeric plants, and recently posted some tips on low-water use for gardeners. California has implemented emergency regulations to conserve water during their drought, and the ones related to landscaping are the sort of common sense practices that xeric-minded organizations and gardeners have always touted:

  • Avoid runoff when irrigating.
  • Don’t irrigate during or 48 hours after measurable precipitation.

This post goes into more details on the restrictions, which, along with scheduled days or times of watering, are pretty common municipal regulations in drought-stricken areas.

Avoid runoff when irrigating

Runoff obviously can come from too much water. Of course, good planning of landscape, plant selection and irrigation choices upfront can prevent runoff. Correct an existing problem by first checking the area after the system runs. If you normally water while at work, do a manual run so you can test your system on the weekend. If you have runoff, study where flow occurs. If it’s down a slope, consider terracing the lawn area or welling around the tree or shrubs that you’re watering. You can also cut watering time, of course. If you’re worried about one tree or ornamental that needs more water, cut the irrigation system watering time and supplement the tree’s water every once in a while with a hose or bucket. Don’t waste all of that water irrigating concrete or pavement, and possibly weeds, just to keep one plant healthy. For a small lawn or several plants on a drip system, you can decrease watering time and increase frequency if necessary.

terraced lawn to prevent sprinkler runoff

This Albuquerque lawn has some bermuda grass, but notice the terrace to avoid runoff. Also, note the exposed drip lines being reset in the xeric garden area on lower right.

The runoff might be from a misdirected, leaky, plugged or defective head or emitter. It’s easy to turn and redirect the head so the water goes where it should. A small leak in the system can waste hundreds of gallons of water. Plugged sprinkler heads are a common cause of pooled or misdirected water. Running a stiff wire, such as a straightened paper clip, through the emitter hole can clear some debris. If the entire head is full or dirt or grass, you can turn off your system, lift and unscrew the head, soak it and use a small wire brush to clean it. Then rinse it and screw it back on.

Avoid watering a wet lawn

This should be a no-brainer, but I already ranted in my previous post about neighbors who left their automatic sprinklers on no matter the weather. My best advice is to set automatic sprinklers to “manual” and water regularly but only as needed based on weather conditions. You can set a reminder on your smartphone or other device to jog your memory if that’s a concern. But it’s sometimes more difficult to remember to override the automatic setting on the sprinkler, especially if you’re not there to do it! Otherwise, pay attention to the weather forecast each evening and override the auto setting when rain is predicted the night before so you don’t have to add the task to your busy morning schedule. You can always water a little in early evening or the next morning if the forecast is off the mark.

Of course, if you’ve switched out some or all of your turf for a xeric landscape, at least you are using less water. It also means less need for an automatic system. Most xeric plants need such infrequent watering that you’re best served by a manual irrigation system or the totally manual system of carrying a water bucket from your rain barrel only to the plants that need a little more water — and only when they need it!

raised ornamental bed bubblers

We raised part of this bed and replaced spray heads with bubblers to conserve water.

Other water-saving tips

  • Water early in the morning, especially if you live in a hot climate. Your plants take up more water before the stressful heat of the day, and if you’re using spray irrigation, less water evaporates.
  • Use drip irrigation when possible instead of sprays and sprinklers, or at least keep the spray as low as possible. Spraying water can lead to some leaf diseases, and you want most of the water to go into the plant’s roots, not into the air.
  • Well around plants, especially new plants, any plant that needs more water than others, and anything planted on a slope to trap the water.
  • Choose xeric, low-water and native plants.
  • Use mulch as appropriate to help keep plants cool and roots damp.

    welled shrubs

    Wells around shrubs at Tucson area nonprofit

Of course, it never hurts to call in a professional landscaper or other pro to get some help with your irrigation system or to better plan your lawn and garden for low-water use. For example, avoiding steep slopes in your landscape (with terraces and other strategies) can prevent water runoff, and use of microclimates can increase plant viability while decreasing water needs.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s